FEA Assignment Example | Topics and Well Written Essays - 1750 words

FEA - Assignment ExampleThe results are then used to assay weight optimisation of the mannikin. The limits of the designed model are the face bearing the interference, strength of the load and the fixed points which are not alterable. The only changing variables are the geometry and materials used.The model was then analysed in the SimulationXpress Analysis Wizard. The first step in this process was to fix the position of the 4 holes where the bracket will be fastened to the consistency of the expression. This is carried out in the fixtures section and the faces assigned as fixed geometry as shown in figure 2. This fixes the lower section of the bracket to its location in the machine, structure or component where it will be employed.The external load on the geometry is a force of 1kN and is applied on the region of 750and 50mm from the upper section of the load bearing face. This force does not act on the whole region hence a sketch is created 50mm from the upper section and cr eating a split trace to allow the force to applied on the hatched region of the load bearing face on the drawing. Figure 3 shows the model with the split clientele created.The simulation results are produced giving the stress, displacement, deformation and the safety factor. Determining the maximum displacement and stress is the key objective at this point. The maximum Von Misses stress is 737.96mPa eyepatch the yield stress is 620.422mPa. This shows that the stress experienced is higher than the yield stress and hence failure due to the 1KN load applied. This is shown in figure 5.The results from part A are used to carry out a plan of the bracket which are then validated with Finite Element Analysis. The main objective of this redesign work is to reduce the weight of the bracket by at least 10% and the deflection should not be more than 10%.In this redesign work, the material was the main focus for reducing the weight of the bracket. The aim was to select a material similar to steel but is lighter in weight. aluminium